Sim2 Multimedia Grand Cinema RTX 55TV - Manual (Page 16)

16
FUNCTION BUTTONS ON THE RTX 55TV CABINET
The control panel (Fig. 6) located on the upper part of the cabinet
(top right), allows you to operate all the main functions even
without the remote control. The main power switch ([32] Fig. 7)
is located at the back of the cabinet, on the left hand side.
NOTE: The “ESC” and “AUTO” buttons (Fig. 6) are not acti-
ve.
SWITCHING ON AND OFF
Switching on in stand-by
Set the main power switch ([32] Fig.7) to the “I” position to
power up the appliance: the two Leds (blue and red) in the
front panel at the top right will light up simultaneously, then
after about 15 seconds, only the blue Led will remain alight. In
this situation, the appliance is in stand-by mode, ready to be
switched on for viewing.
Switching on video and audio systems
With the system in stand-by, press one or two number buttons
[2] on the remote control: if just one number is pressed, the
system waits briefly for a second number, then selects the pro-
gramme corresponding to the number selected and after a few
seconds the appliance will come into operation, probably with
nothing other than ʻsnowʼ on the screen. This mass of randomly
moving dots will appear typically when a television is not tuned
to any channel.
During operation, the two Leds on the top right of the cabinet
front will keep you informed as to the status of the system. Ta-
ble 2 lists the possible conditions of the Leds and the relative
significance.
Switching off to stand-by
Pressing button [1] on the remote control, the appliance switches
off, reverting to stand-by, and the two Leds will blink until the
projection lamp has been cooled to a safe temperature by the
fan.
CAUTION: Do not return the main power switch ([32] Fig. 7) to
the “O” position and do not unplug the power cable immediately
after switching the appliance back to stand-by. Wait at least
1 minute for the red and blue Leds to stop blinking. With the
appliance in the stand-by condition, it can be switched on for
full viewing and listening simply by pressing one of the number
buttons [2] on the remote control, or alternatively the on-off
button [1]. For the projection lamp to be cooled by the fans, the
appliance must remain powered up in stand-by.
[ 32 ]
Off
Initialisation
Status
Leds on cabinet
Red LED Blue LED
Stand-by
On
Cooling
Reception of infrared
signal with television
switched on
: Off : On : Flashing
Table 2
[ 26 ] [ 27 ] [ 28 ] [ 29 ]
[ 31 ]
[ 30 ]
ESC
ME NU
AUTO
Fig.6
Fig.7