Sony SRP-X500P - Manual (Page 14)

14
Installation
Installation
Installing the tuner units
Up to two WRU-806 UHF Synthesizer Tuner Units (not
supplied) or two URX-M1 Tuner Units included in the
UWP-X1/X2 (not supplied) can be installed in the SRP-
X500P.
Notes
• To prevent the production of noise, be sure to turn the
SRP-X500P off before installing or removing the tuner
units.
• When installing the tuner unit, insert it fully into the
tuner slot of the SRP-X500P and secure it with the latch
on the slot.
• Do not touch the inside of the tuner unit slots.
1
Turn off the SRP-X500P, check the top and bottom
sides of the tuner unit, and then insert it into the slot.
2
Turn on the SRP-X500P and perform the group and
channel settings for the tuner unit, following the
instructions in “WRU-806 channel setting” (page 15).
Make the same group and the channel settings for the
wireless microphone used in conjunction with the
tuner unit.
For details on settings of the UWP-X1/X2, refer to the
Operating Instructions supplied with the product.
3
Turn on the wireless microphone and check that the
tuner unit is receiving a signal from the microphone.
While a signal is being properly received from the
microphone, the RF indicator on the tuner unit lights
up.
If the RF indicator does not light up, this means the
channel setting for the microphone is different from
that of the tuner unit, or that the battery in the
microphone is running down.
To remove the tuner unit
Pull the latch securing the tuner unit to the side and pull out
the tuner unit.
About blank panels
Two blank panels (large and small) are attached to the
front of the SRP-X500P.
Remove both of these panels to perform settings.
After completing the settings, reattach the panels to
prevent malfunctioning of the unit and to keep the tuner
units from falling off the slot.
When the input level controls are used
When the input level controls are not used
Tuner unit
Latch
Tuner unit
Latch
Blank panel (large)
Blank panel (small)
Blank panel (large)