Sony SRP-X500P - Manual (Page 28)

28
Controls
lighting equipment turns on when an EMG tally signal is
output from pin 24 (OUTPUT 10).
Programming a remote commander
Commands that control the SRP-X500P functions can be
stored to an optional programmable remote commander
(RM-AV3000 series, etc.).
These functions are the following:
• The AV/RGB SELECT buttons
• The PROJECTOR POWER switch
• The MASTER volume control
− Turning up the volume
− Turning down the volume
− Muting of the volume
For details on how to program your remote commander,
refer to the operation manual that was supplied with it.
1
Keep pressing the IR OUTPUT MODE button for 2
seconds or more.
The button lights up green and the remote emitter/
sensor lights up red when the SRP-X500P is ready to
emit commands from the remote emitter/sensor.
Note that no audio/video is output from the SRP-
X500P during this time.
2
Operate the SRP-X500P function to be programmed
to the remote commander as follows.
To program the function of the AV/RGB
SELECT buttons
Press the AV/RGB SELECT button to be
programmed to the remote commander so that it lights
up.
To program the function of the PROJECTOR
POWER switch
Press the PROJECTOR POWER switch so that it
lights up.
To program the function for turning up the
master volume
Rotate the MASTER control to the 11 o’clock
position so that the MASTER MUTING indicator
lights up.
To program the function for turning down the
master volume
Rotate the MASTER control to the 9 o’clock position
so that the MASTER MUTING indicator lights up.
To program the function for muting the
master volume
Rotate the MASTER control to the –
∞
position so
that the MASTER MUTING indicator lights up.
3
Place the remote commander so that its top is pointed
towards the remote emitter/sensor, and then ready the
remote commander for programming commands from
the SRP-X500P.
4
Press the IR OUTPUT MODE button.
The button and the remote emitter/sensor flash and
command is output from the remote emitter/sensor.
5
When programming has completed, press the IR
OUTPUT MODE button again.
The button lights up and the command output stops.
6
To program other functions, repeat this procedure
from step 2.
7
Keep pressing the IR OUTPUT MODE button for 2
seconds or more.
The button and the remote emitter/sensor turn off and
the SRP-X500P returns to normal status.
After programming has completed, be sure to verify
that the command has been correctly programmed or
not. If not, repeat the procedure from step 1.
Programmable remote
commander
10 cm or less