Sony SPP-A968 - Manual (Page 51)

Additional Information
Additional Information
51 US
It means
Number of messages not yet played back. The indicator
shows up to 99 messages. After that, ”99“ flashes to tell you
that there are 100 or more messages.
Flashes when the day and time is cleared due to a power
interruption, or when you connect the base unit to the AC
outlet for the first time (pages 9 and 29).
The announcement only mode is selected (page 32).
The recording area is full. Erase unnecessary messages
(page 34).
Remedy
• Make sure you entered your area code correctly
(page 13).
• You may need to change the number of digits of the
phone number (page 45).
• This function may not work when the phone is
connected to a Private Branch Exchange (PBX).
• If the call is from an office which uses multiple lines,
the phone number may not match the number you
put in the memory.
• If you stored the phone number with an outside line
access digit in the Phone Directory because the phone
is connected to a Private Branch Exchange (PBX), the
phone number will not match the Caller ID data.
• Wipe the charge terminals of the base unit and the
handset with a soft cloth for better contact of the
charge terminals.
• Make sure the handset is placed on the base unit
properly.
• The battery pack was charged less than 12 hours (due
to power failure, etc.).
• The usable life of the battery has expired and needs
replacement.
Symptom
You cannot dial the number
from the Caller ID list.
The memory match function
does not work.
The CHARGE lamp does not
light up when you place the
handset to charge.
The battery duration is short.
Power source/battery
Message number indication
The message number indicator on the base unit shows the following information.
Note
If any of the remedy did not work, there may be something wrong with the
handset. Replace the handset on the base unit, then pick it up and try again. If the
handset is on the base unit, pick up the handset and replace it again.
When the counter shows
Number (0-99)
P
A
F
Caller ID