Parameter descriptions, Set parameter defaults, Host interface select – Symbol Technologies LS 1000 User Manual
Page 40: Set parameter defaults host interface select, Appendix, Section of this manual
Advertising
4-6
LS 1000 Product Reference Guide: Chapter 4, Programming the LS 1004
Parameter Descriptions
Refer to the Default table in the front of this chapter for the default settings for each
parameter type.
Set Parameter Defaults
Scanning the SET ALL DEFAULTS bar code returns all parameters to the default values
listed in the Default Table.
Host Interface Select
Scan the bar code corresponding to your host type. You must select a host type when
you first set up the scanner and whenever you change host type.
SET ALL DEFAULTS
SET RS-232C HOST
SET SYNAPSE HOST
coverBook Page 6 Monday, December 1, 1997 2:19 PM
Advertising