Symbol Technologies LS 1000 - Manual (Page 5)

vii
Contents
Factory Service
Symbol Support Center
Chapter 1. Introduction and Set-up
Introduction
Audience
Set-Up3
Unpacking
Installing the Cable
Switching Cables
Connecting to a Host
Chapter 2. Scanning
Introduction
Ready, Test, Scan
Aiming
Chapter 3. Maintenance & Specifications
Introduction
Maintaining the LS 1000 Scanner
Accessories
LS 100x Technical Specifications
LS 100x Decode Zone
Chapter 4. Programming The LS 1004
Introduction
Scanning Sequence
Scanning Sequence Example
Errors While Scanning
Parameter Descriptions
Set Parameter Defaults
Host Interface Select
Power On Beep Enable/Disable
Beeper after Decode
Beeper Tone
Beeper Volume
coverBook Page vii Monday, December 1, 1997 2:19 PM