Sony Ericsson DFP-D3000 - Manual (Page 44)

9-10 DFP-3000
2. Setting of output preset corresponding to SDDS
The following shows an example of the settings of the Preset Configuration of the setup software at this
time.
Set the Fallback of the SDDS to “No Fallback”. (Refer to (1) in the example of settings screen.)
With this system configuration, do not adjust the B-chain of the DFP-D3000 in order to use the B-chain
function of the existing cinema microprocessor. To prevent accidents, set the EQ setting at the Preset
settings to OFF. (Refer to (2) in the example of settings screen.) To send signals to the AUX input of the
DFP-D3000 from another cinema processor, the AUX input connected to that signal can be selected as
the Fallback setting.