Sony Ericsson DFP-D3000 - Manual (Page 54)

9-20 DFP-3000
4. Procedures for setting up the CP-500
First, confirm that the CP-500 is equipped with firmware version 1.51 or higher.
Next, enable the “Auto Digital” function by referring to the CP-500 Installation Manual. The source
format of the “Auto Digital” function should be set to Dolby A (SK2), and the target format to Dolby
Digital (SK4). It is crucial that Dolby SR (SK3) is not assigned as a source format of the “Auto Digital”
function. These instructions assume that the CP-500 preset is configured for Dolby A on SK2, Dolby SR
on SK3, Dolby Digital on SK4 and Non Sync 1 on SK6.
Set the level of all output channels of the CP-500 to the DFP-D3000 AUX Port input reference level.
(
_8.2 dBu. This value is equivalent to _10 dBV or 300 mV.)
During operation, ensure that the master fader on the CP-500 is disabled or kept at 7.0 at all times.
5. Setting up the DFP-3000
First, confirm that the DFP-D3000 is equipped with firmware version 2.60 or higher.
The DFP-D3000 is configured for SDDS on Preset 8 and that Dolby Digital is on Preset 6 (using the
AUX1 input). We recommend that you don’t change Preset assignments from the defaults unless there is
a strong requirement for doing so. If Preset assignments are to be changed, we recommend setting up the
theatre completely and confirming that all is working correctly before making the reassignments.
In this system, set the fallback structure corresponding to the SDDS input (Preset 8) of the DFP-3000 as
follows. The Preset Configuration screen of the Setup software will display as follows. ((1) of the follow-
ing diagram.)
SDDS
→
[AUX 2]
→
NR2 (Set the AUX2 input when using the DTS, etc.)