Sony Ericsson DFP-D3000 - Manual (Page 45)

9-11 DFP-3000
3. Setting of output preset corresponding to AUX1 or AUX2 (Optional)
Set the Fallback of the AUX input to the corresponding AUX input (so that the Fallback function does not
operate). Set the AUX input equalizer setting to the same setting as the SDDS format. The following
shows an example of the settings of the Preset Configuration screen of the setup software.
4. Precautions in operations on the above system
. Use the DFP-D3000 master control at 0.0 dB. However, if the signal level of the SDDS input must be
controlled at the DFP-D3000 according to the settings of the existing system, adjust the master control.
. Always set the preset switches (eight large switches on the front panel) of the DFP-D3000 to the preset
(Preset 8 at shipment) corresponding to SDDS. If film sound processor other than the DFP-D3000 are
connected, select the preset corresponding to the external processor or the preset corresponding to the
SDDS as necessary.
. In some cases, the Preset Configuration screen cannot be exited if the AUX input Fallback setting is not
set for some DFP-D3000 setup software versions. In such cases, set the Fallback function without using
the setup software. In this case, set the Fallback by selecting the preset number.