Sony Ericsson DFP-D3000 - Manual (Page 60)

9-26 DFP-3000
9.7 Connecting the DTS-6, DTS-6D and DFP-D3000
9.7.1 Outline of System
9.7.2 Requirements of SDDS Side
The DFP-D3000 software version must be more than 2.21. You can check the software version at the
Status screen of the DFP-D3000 menu. For details, refer to the DFP-D3000 operation manual.
9.7.3 Connecting the DTS Processor DTS-6
DTS-6 side output: Use the DTS-6 STEREO terminal (15-pin D-sub connector).
m
1.
No DTS Automation interface board is necessary.
2. The DTS output board operation mode in the DTS-6 system must be set to the CP-200 mode. (Set
using two DIP switches. For details, refer to the DTS-6 manual.)
Amp.
DTS Digital
Decoder
DTS-6 / DTS-6D
DFP-D3000
Automation
System Out
AUX1 / AUX2
DFP-R3000
Analog Reader
DTS Reader
Reader
Opt1 / Opt2