Samsung DVD-HR738/ - Manual (Page 123)

R
eference
English - 123
Remote Control Unit
Read the table of contents and then
find and read the section describing
your problem, follow the instructions
given.
Plug your HDD &DVD RECORDER
off and on.
If the problem still persists, contact a
nearby Samsung service centre.
Checkpoint 1
Checkpoint 2
Checkpoint 3
Other problems.
The remote control doesn't work.
A recorded disc is played with only
the subtitle and the audio signal
which were selected during recording.
Checkpoint 1
Is it possible to change a subtitle and an audio
signal on a recorded disc?
Other
Press and hold the PROG( )
buttons on the front panel of the
Recorder for more than 5 seconds
with no disc in the unit. All settings
including the password will revert to
the factory settings. Do not use this
unless absolutely necessary.
(Note that this function is possible
only when no disc is inserted.)
Checkpoint 1
I forgot my password for parental supervision.
Point the remote control at the remote
control sensor on your HDD & DVD
RECORDER. Allow for proper
distance. Remove obstacles between
your HDD & DVD RECORDER and
the remote control.
Check whether the batteries are
drained.
Check the TV/DVD selection button
setting.
Check whether TV control button is
selected or not.
Checkpoint 1
Checkpoint 2
Checkpoint 3
Checkpoint 4
If snow noise appears on the screen,
it means that TV does not support
HDCP (High-bandwidth Digital
Content Protection).
Checkpoint 1
Abnormal HDMI output screen.
Check your TV system setup
correctly.
Please refer to the user’s manual of
your TV. Checkpoint 1
Checkpoint 2
HDMI output Jitter
HDMI (HR738 Only)
Check whether the mode is stop
mode or not. You can switch HDMI
mode in stop mode.
Check the Video output is HDMI
enabled.
Check the connection between the
TV and the HDMI jack of the HDD &
DVD RECORDER.
See if your TV supports HDMI.
Checkpoint 1
Checkpoint 2
Checkpoint 3
Checkpoint 4
No HDMI output.
HR733-HR738_XEU_89~127 6/23/06 10:35 AM Page 123