Samsung DVD-HR738/ - Manual (Page 24)

24 - English
C
onnecting & Setting Up
Case 2 : Connecting to a TV with
DVI Jack
• Using the DVI Adapter Cable(not supplied),
connect the HDMI OUT jack on the rear of the
HDD & DVD RECORDER to the DVI IN jack of
your TV.
• Using the audio cables, connect the AUDIO
(red and white) OUT jacks on the rear of the HDD
& DVD RECORDER to the AUDIO (red and white)
IN jacks of your TV. Turn on the HDD & DVD
RECORDER and TV.
• Press the input selector on your TV remote control
until the DVI signal from the HDD & DVD
RECORDER appears on your TV screen.
■ To use HDMI cable, make the Audio/Video
connection before plugging in the power cord
or after finishing the “Plug & Auto Setup.”
Do not connect the HDMI cable while the
“Plug & Auto Setup” is progressing.
■ Progressive scan automatically activates when
HDMI is connected.
■ If your TV does not have Bitstream decoder,
you must set the digital audio output to PCM in
order to watch through the HDMI output.
(See pages 38~39)
■ Depending on the HDMI device (TV/HDMI
Receiver) you use, audio may not be
supported. If TV/HDMI Receiver does not
support Dolby digital, Audio output is not
available when you set Digital output as
'Bitstream' in Audio setup menu. In this case,
set the digital audio output to PCM. If TV/HDMI
Receiver does not support DTS, Audio output
is not available when you play disc in DTS
format.
■ You can switch from the HDMI output to other
output only in stop mode.
CAUTION
■ HDMI (High Definition Multimedia
Interface)
HDMI is an interface to enable the digital
transmission of video and audio data with
just a single connector. Since HDMI is
based on DVI, it is completely compatible
with DVI. The only difference between
HDMI and DVI is that HDMI supports
multi-channel audio.
Using HDMI, the HDD & DVD
RECORDER transmits a digital video and
audio signal and displays a vivid picture
on a TV having an HDMI input jack.
■ HDMI connection description
HDMI connector - Both uncompressed
video data and digital audio data
(LPCM or Bit Stream data).
- Though the HDD & DVD RECORDER
uses a HDMI cable, the HDD & DVD
RECORDER outputs only a pure digital
signal to the TV.
- If TV does not support HDCP
(High -bandwidth Digital Content
Protection), snow noise appears on the
screen.
NOTE
red white
white
red
< DVD-HR738 >
HR733-HR738_XEU_01~58 6/23/06 10:18 AM Page 24