Samsung SWL-2200C - Manual (Page 60)

60
adapter and network.
* LED(Power/Link Status)
- This LED indicates that power has been applied, and the card is
functional. In normal operation mode with Card Power Management
disabled, it will be steady-on if the card is connected with a AP and
it will be blink slowly if the card in not connected with a AP.
With Card Power Management enabled, it will blink rapidly
(several times per second).
* LED blink slowly.
- The adapter was unable to make contact with the named wireless
network. Verify the ESSID value,in the config.opts file matches
the network name of the access point.
4. MODULE PARAMETERS
==============================================================
irq_list Select IRQ to use
-1 = auto-assign (default)
networkmode Select 802.11 Network type
1 = Infrastructure Mode(default)
3 = Ad-hoc Mode
stationname Station name
essid
Network name (SSID)
Sets the independent network name in ad-hoc mode.
Sets the desired network (desired SSID) to connect
to if using an access point.
default is card-configured
psmode Power Saving Mode
(! if you enable this mode,there is degradation in the throughput performance.)
0 = disabled(default)
1 = enabled
wepreq Enables or diabled encryption of Data.
0 = disabled(default)
3 = 40 bit WEP
7 = 104(128) bit WEP
keyid Designates which of the keys is to be used for the enciphering of data
that is transmitted by this action.
0 .. 3(default=0)
In case of 104(128) bit WEP it only supports the keyid 0.