Smart Technologies Smart Board V280 - Manual (Page 37)

27 | CONNECTING YOUR INTERACTIVE WHITEBOARD TO A COMPUTER
NOTE
When you press the nib of the pen against your interactive whiteboard’s
screen, the LED light on the pen illuminates.
4. Repeat step 3 until you arrive at the last point.
NOTE
If you’re not satisfied with the precision of a particular point, press the left
arrow key on your computer’s keyboard to repeat the orientation for that point.
5. At the last point, touch the center of the target firmly and continue pressing
until the message “Please wait while Orientation completes” appears.
The Orientation screen closes.
The orientation procedure can be six or fifteen touches, depending on the precision
setting you specify in your SMART Hardware Settings in the SMART Notebook control
panel. The following procedure shows you how to change the precision setting.
To change the
orientation precision
1. Select the SMART Board icon once in the Windows notification area, and then
select Control Panel.
2. Select SMART Hardware Settings.
3. Select Orientation/Alignment Settings from the drop-down list.
4. Select the desired setting, and then press OK.
5. Perform an orientation procedure so that the precision change takes effect.
Good Orientation Point
The pen touches the center of the target.
Poor Orientation Point