Samsung SCC-ZM395N - Manual (Page 8)

Version 1.1
- 8 -
3-3. Hardware Spec.
Rear View
① CN207 : I/O Connector-1
Pin NO Pin Name Description Normal Active I/O
1 RxD
Read Data
CMOS 5V (Low: Max 0.8V, high:min.3V)
I
2 TxD
Send Data
CMOS 3.3V (Low: Max 0.1V, high:min.2V)
O
3 GND Ground (for TxD/RxD) -
4 DC IN Power input (DC +9V ~ +15V) I
5 GND Ground (for DC IN) -
6 VBS Composite Video Output O
7 GND Ground (for VBS) -
8 LPULSE Line Lock Control Clock I
9 GND Ground (for VBS) -
Molex 52207-0960
② CN3 : Connector for upgrading Camera Program (※ used for factory only)
Pin NO Pin Name Description Normal Active I/O
1 FSPE JTEG Upgrade Mode Setting +3.3V 0 I
2 DSPSCK JTEG Upgrade Clock I
3 DSPSDO JTEG Upgrade Data Output O
4 DSPSDI JTEG Upgrade Data Input I
5 DSPSTB JTEG Upgrade Chip Selector I
6 GND Board Ground -
7 V+3.3V JTEG Jig Power Supply(Max 0.2A) O
Yeonho Electronics, 12505WS-07A00
③ CN208 : Connector for communication (※ used for factory only)
Pin NO Pin Name Description Normal Active I/O
1 V+5V Jig Power Supply(Max 0.2A) O
2 TXD UART (Txd) O
3 RXD UART (Rxd) I
4 GND Board Ground -
Yeonho Electronics, 12505WS-04A00
①
Zoom Lens
Tele/Wide Switch
②
③
9 8 7 6 5 4 3 2 1 1 2 3 4
7
6
5
4
3
2
1