Sharp MX-M850 - Manual (Page 52)

52
IMPORTANT POINTS WHEN USING THE BYPASS TRAY
• When using plain paper other than SHARP standard paper or special media other than SHARP-recommended
transparency film, or when printing on the reverse side of previously used paper, the paper must be loaded one sheet
at a time. Loading more than one sheet at a time will cause misfeeds.
• Before loading paper, straighten any curling in the paper.
• When adding paper, remove any paper remaining in the bypass tray, combine it with the paper to be added, and
reload as a single stack. If paper is added without removing the remaining paper, a misfeed may result.
Inserting paper
Place paper that is 7-1/4" x 10-1/2" (A5) or smaller in the horizontal orientation.
Inserting tab paper
To print on tab paper, load tab paper in the bypass tray with the print side face up.
On the MX-MFX2 bypass tray, the special guide is attached to the bottom edge bypass guide. The special guide is stored
under the front cover of the large capacity trays. After using the guide, remove it and replace it in its storage location.
Inserting transparency film
Bypass tray (MX-MFX1) Bypass tray (MX-MFX2)
Left
binding
Place the first sheet of tab paper so that the tab is away from you.
Right
binding
Place the first sheet of tab paper so that the tab is toward you.
• Use only tab paper that is made of paper. Tab paper made of a material other than paper (film, etc.) cannot be used.
• To print on the tabs of tab paper...
In copy mode, use "Tab Copy" in the special modes. In print mode, use the tab print function. For more information on
these functions, see the Copier Guide and the Printer Guide.
• Use SHARP-recommended transparency film. When inserting transparency film
in the bypass tray, the rounded corner should be at the far left when the film is
oriented horizontally, or at the far right when the film is oriented vertically. Place
the film face up.
• When loading multiple sheets of transparency film in the bypass tray, be sure to
fan the sheets several times before loading.
• When printing on transparency film, be sure to remove each sheet as it exits the
machine. Allowing sheets to stack in the output tray may result in curling.
Front
side
Front
side
Front
side
Front
side
Horizontally Vertically