Select Products II - Manual (Page 13)

13
The following two screens will be displayed only if the DMX fan option is turned on.
[ /Enter ]
FChn 025 - This allows you to set the DMX fan control channel (ONE or first channel of
the BLOCK) to any channel between, and including, 001 and 512.
[ /Enter ]
Foff OFF - When turned on, this feature allows you to turn the fans in the color
changers off from the lighting console. This is done by sending a level of 8% to the fan
control channel. This unusual level was chosen to minimize the probability of
unintentionally turning the fans off.
OPTIONS
This menu is where you select the power supply display mode.
Pressing [ - ] at any of the following options will bring a up a question mark (?) behind
the option. Pressing [ + ] and [ - ] will increment and decrement numbers or toggle
options. Pressing [ /Enter ] will confirm your selection and the question mark will go
away.
[ - ]
Disp % - This option allows you to select how the power supply will display position
information in the status menu and in the commands menu. The options are decimal (0
- 255), % (0 - 100), or hex (0 - FF).
[ /Enter ]
Run REG - This option affects the main run screen which is displayed after initial power
up of the power supply. The purpose is to minimize the flashing display characters
which may be distracting if seen. When set to REG, the display will alternate between
the selected channel range, DMX OK or NO DMX, and *ALERT* if any alerts are
present. When set to MIN, the display will not alternate. You will see the display as
follows:
001 - - 048
If NO DMX signal is present, you will see the display (the first - changes to a + ) as
follows:
001 + - 048