Select Products II - Manual (Page 6)

6
Power Supply
The power supply converts the DMX512 signal level from the lighting console into
Coloram I/Coloram II control signal which it then sends to each color changer along with
24 volts DC. The power supply features a DMX bypass relay to pass the DMX signal to
the DMX output connector in the event of AC power loss.
The power supply features an 8 character LED display and three selector buttons. This
user interface is used to select the starting DMX channel, set operating modes, send
remote commands to the color changers and view color changer status.
Coloram II Cable
The Coloram II Cable connects the Coloram II Power Supply outputs to the Coloram II
Color Changers or other products and provides them with power and control signal. The
Coloram II Cable uses 4-pin XLR connectors on either end and consists of two 14 AWG
conductors and a 22 AWG twisted, shielded pair.
Note: Colroam II Cable is used in the Coloram II System and in the Forerunner System.
It may be referred to as either Coloram cable or Forerunner cable.
The Coloram II Power Supply menu
This section describes the power supply menu.
The following diagram is the eight character display and the three push buttons:
/ENTER
+
_
DISPLAY
The following diagram is an overall view of the power supply menu structure: