Commands – Select Products II User Manual
Page 14
14
If an alert has been triggered with the presence of DMX signal, you will see the display
(the second - changes to a + ) as follows:
001 - + 048
If an alert has been triggered without the presence of DMX signal, the display will look
as follows:
001 + + 048
[
/Enter
]
Reset: This option allows you to reset all parameters to factory default. This resets all
parameters found in the setup menu, the display to read out in %, and erases all color
changer/gobo changer status information.
COMMANDS
This is the menu you use to send local commands to the color changers and gobo
changers.
Pressing [
-
] at any of the following options will bring up a question mark (?) behind
the option. Pressing [
+
] and [
-
] will increment and decrement numbers or toggle
options. Pressing [
/Enter
] will confirm your selection and the question mark will go
away.
[
-
]
DMX ALL - This will send commands to all color changers or gobo changers connected
to this power supply. Pressing [
/Enter
] allows you to select the DMX channel of the
individual color changer or gobo changer which you wish to send commands to.
Channels with color changers or gobo changers set to them will be indicated by an
asterisk.
[
-
]
Re-Init - This will cause the color changers or gobo changers to re-calibrate their
gelstrings or gobo carriers.
[
/Enter
]
Shutdown - This will shut down motor drive in the selected color changer or gobo
changer. The unit will not respond to position commands.
[
/Enter
]