Select Products II - Manual (Page 15)

15
Pos - This allows you to move the gelstring or gobo carrier independently from the
lighting console.
[ /Enter ]
Fan - This allows you to change the fan speed independently from the lighting console.
[ /Enter ]
Mtr - This allows you to limit the top speed at which the motor will run. This applies to
Coloram II.
Installing / Connecting the Coloram II Power Supply
To get your Coloram II Power Supply up and running, follow these hookup and checkout
procedures.
1. Mount the power supply
The Coloram II Power Supply is designed to be free standing, truss mounted, or
rack mounted.
The power supply comes with a mounting bracket which hooks over the pipe or
truss of your lighting rig and is then locked into place with a thumb screw. If you
have selected this mounting method, connect the power supply's safety cable by
clipping it around the pipe or truss.
The power supply can also be mounted into a 19" rack using the optional
Coloram II Power Supply rack mount kit. The rack mount kit will accommodate
two Coloram II Power Supplies side by side.
2. Connect the color changers to the power supply
Connect the color changers to the power supply using 4-pin Wybron DMX
power/signal cable.
Refer to the HEAD-FEET RESTRICTION section of the manual for details of the
length of cable runs.
Note: The Wybron DMX Cable has been specially designed to minimize voltage
drop -- use only Wybron supplied cable.