Sharp Notevision PG-C355W - Manual (Page 49)

-47
Useful Features
0
0
0
0
Phase
Clock
Pict. SIG–ADJ SCR PRJ Net.
H-Pos
V-Pos
Reset
Auto
640 x 480
On
Standard
Auto
SEL./ADJ.
RETURN ENTER
END
Resolution
Auto Sync
Signal Type
Dynamic Range
Video System
Signal Info : 800 x 600
H 60.3 kHz / V 37.8 Hz
1
3
4
5
6
2
7
Signal Adjustment (“SIG-ADJ” Menu)
1 1 1 1 1 Adjusting the Computer Image
If the optimum image cannot be obtained with Auto
Sync adjustment, use the SIG-ADJ function.
Note
• To reset all adjustment items, select “Reset” and
press ENTER.
• The adjustable range of “H-Pos” (H-Position)
and “V-Pos” (V-Position) may vary depending
on the screen resolution of the computer.
Selectable items
Clock
Phase
H-Pos
V-Pos
Description
Adjusts vertical noise.
Adjusts horizontal noise (similar to
tracking on your VCR).
Centers the on-screen image by
moving it to the left or right.
Centers the on-screen image by
moving it up or down.
2 2 2 2 2 Resolution Setting
Ordinarily, the type of input signal is detected and the
correct resolution mode is automatically selected. How-
ever, for some signals, the optimal resolution mode in
“Resolution” on the “SIG-ADJ” menu may need to be
selected to match the computer display mode.
Note
• See “Checking the Input Signal” on page 48 for
information on the currently selected input sig-
nal.
3 3 3 3 3 Auto Sync Adjustment
Used to automatically adjust a computer image.
Note
• Auto Sync adjustment is also performed by
pressing AUTO SYNC on the projector or on
the remote control.
• The Auto Sync adjustment may take some time
to complete, depending on the image of the
computer connected to the projector.
Selectable items
On
Off
Description
Auto Sync adjustment will occur when
the projector is turned on or when the
input signals are switched, when
connected to a computer.
Auto Sync adjustment is not automati-
cally performed.
Menu operation Page 43
4 4 4 4 4 Signal Type Setting
This function allows you to select the input sig-
nal type RGB or Component for COMPUTER/
COMPONENT 1, 2 or DVI-D.
Description
Input signals are automatically recog-
nized as RGB or component.
Set when RGB signals are received.
Set when Component signals are
received.
Selectable items
Auto
RGB
Component