Sharp Notevision PG-C355W - Manual (Page 56)

-54
Setting up the Projector Network Environment (“Network” menu)
1 1 1 1 1 Setting a Password
If you do not want others to change the setting
for the “Network” menu, set a password.
Setting a Password
1
Select “Password”, then press |
| | | |.
• The screen for entering the password ap-
pears.
2
Press '
' ' ' ' or " " " " " to set the first digit in
“New Password”, then press |
| | | |.
3
Enter the remaining 3 digits, then
press ENTER.
• To return to the previous digit, press \.
4
Enter the same password in
“Reconfirm”, then press ENTER.
• The status for “Password” changes to “En-
able”.
Note
• Once after the password is set, you must enter
the password to change the “Network” menu
settings.
Changing the Password
1
Select “Password”, then press |
| | | |.
• The screen for entering the password ap-
pears.
2
Enter the password in “Old Pass-
word” using '
' ' ' ', " " " " ", | | | | | and \ \ \ \ \, then
press ENTER.
3
Enter the password in “New Pass-
word” using '
' ' ' ', " " " " ", | | | | | and \ \ \ \ \, then
press ENTER.
4
Enter the same password again in
“Reconfirm” using '
' ' ' ', " " " " ", | | | | | and \ \ \ \ \,
then press ENTER.
Note
• If you do not need the password protection for
the “Network” menu settings anymore, press
ENTER without entering new password in steps
3 and 4.
• To cancel the password settings, press RETURN.
If you forget the password
If you forget the password, perform the following
procedure to delete it, then set a new password.
On the projector, press
Note
• If ENTER is held down for more than 5 seconds, the
operation buttons on the projector will be locked. (See
page
53 .)
• You cannot use the buttons on the remote control to
delete the password.
Menu operation Page 43
Password
DHCP Client
TCP/IP
Off
Disable
SEL./ADJ.
RETURN ENTER
END
MAC Address XX:XX:XX:XX:XX:XX
Projector XX-XXXX
Pict. SIG SCR PRJ Network
1
3
4
2
Setting the Password
Old Password
New Password
Reconfirm
–
– – – –
– – –
– – – –
Network