Sierra Housewares S5012 - Manual (Page 50)

46
6
Maintenance
Common System Messages
Below is an explanation of the common messages your keypad
might display. Beside each message is a discussion of what re-
sponses are appropriate. If you find the response is ineffective,
call your local C&K service representative.
In the table below, the ellipses (...) represent the specific informa-
tion, such as zone numbers, that follows the system message.
If you notice That means What to do:
Power LED is off The system is not Verify that the rest of the
receiving AC (house building is receiving power;
current) power then call for service.
That
Display reads: A zone is faulted; Correct the fault (by
"Faulted..." cannot fully arm closing doors/windows); or
bypass the zone.
Display reads: A sensor needs Bypass the sensor, or
"Trouble..." service arrange for repair.
Display reads: A sensor may have Call for service.
"Tamper..." been tampered with
Display repeatedly A sensor may need Call for service.
reads: "Trouble..." service
"Tamper..."
Display reads: Any one of your Depending upon your
Ready" sensors may be arming type, your system
faulted may be able to arm. If not,
correct any faulted zones,
then attempt to arm.
Display reads An alarm occurred Refer to "Resetting After an
"Alarm..." Alarm" in Section 4.
Display reads A zone has been Remember the zone is
"Bypass..." bypassed unprotected while bypassed.
You can remove the bypass
(see Section 3), or arm/
disarm with bypass in place.