Seiko FB 390 - Manual (Page 12)

7
Using the Parallel Interface and the USB Interface
Figure 2-7 Connecting the parallel interface cable and the USB interface cable
Connecting to the Power Source
Connecting the Power Cord
Plug the power cord (supplied) into the power inlet at the rear of the printer.
Check that the power switch (located on the front of the printer) is in the OFF position, and then
plug the power cord into the wall outlet.
Turning the Power on and off
To turn the printer ON, press the I mark at the side of the power switch.
To turn the printer OFF, press the O mark at the side of the power switch.
The parallel interface
The USB interface
USB interface
cable
Parallel interface
cable
Parallel interface
connector USB interface
connector
Figure 2-8 Connecting the power cord to the printer
Power switch
Power supply inlet
Power cord