Seiko FB 390 - Manual (Page 23)

18
menu lists, each list containing several settings. You can select a new setting of the menu list and
save it, or just go to the next menu list without altering the current setting.
To enter the Setup Menu System and change the settings
1. Lift the window cover of the printer.
2. Eject any paper currently in the printer (or park tractor paper) then switch the printer
ONLINE .
3. Keep pressing the PARK/LOAD key for 3 seconds.
This starts the Setup Menu System and prints the instructions for using it. The current
setting is underlined.
The print head points to the current selection in the menu.
4. Make a selection from the menu with the keys on the control panel:
Press: To:
PARK/LOAD Move the print head to the next menu selection. Repeat this until
you get the selection that you want.
LF/FF
Save the setting that is currently indicated by the print head
position, and go to the next menu.
ONLINE
Move to the next menu without altering the current setting.
COPY Go to the next menu group.
5. When you have made all of your settings (remember that you don’t have to go all the way
through the menu system), switch the printer off and then turn on again.
Each time you switch the printer on it uses the new saved settings. Keep the printout of the
menu selections so that you know what the current settings are.
To exit the Setup Menu System
Turn the printer off, and then turn on again.
* New settings of the menu will be stored.
NOTE
1. You do not have to go all the way through the menu system. Once you have made all
the changes you want, you only need to exit the Setup Menu System by switching off
the printer. When you switch it on again, the printer will read and use the new settings.
2. When the compressed mode is effective, the High Speed mode and Super High Speed
mode will not be valid.