Seiko FB 390 - Manual (Page 28)

23
Restoring Factory Printer Settings
You can restore to the factory printer settings without having to work through the Setup Menu
System to reset the menus.
To restore to the factory settings:
1. Make sure that the printer is ONLINE
2. Press and hold down the ONLINE and COPY keys on the control panel for 3
seconds.
The LED’s of the POWER and ONLINE on the control panel flash 3 times respectively at
the same time and the printer makes a beep to confirm that the printer’s factory settings
have been restored.
3. Release the keys and switch the printer off and on again.
After these steps, the printer’s factory settings work.
Using the Self Test Functions
Slide Pattern Printing Test
One page printing of ASCII slide pattern is performed by turning power on, while pressing the
LF/FF
key.
Continuous printing of ASCII slide pattern is performed by turning power on, while pressing the
ON- LINE and PARK/LOAD keys.
Maintenance Printing Test (H pattern)
One page printing of H pattern is performed by turning power on, while pressing the ONLINE and
LF/FF
keys.
Continuous printing of H pattern is performed by turning power on, while pressing the COPY key.
ASCII TEST MODE
Version: 390V X.X 20XX/XX/XX
!”#$%&’()*+,-./10123456789:;<=>?@ABCDEFGHIJKLMNOPQRSTUVWXYZ[\]^_’abcdefghijklm
!”#$%&’()*+,-./10123456789:;<=>?@ABCDEFGHIJKLMNOPQRSTUVWXYZ[\]^_’abcdefghijklmn
”#$%&’()*+,-./10123456789:;<=>?@ABCDEFGHIJKLMNOPQRSTUVWXYZ[\]^_’abcdefghijklmno
Figure 5-4 The former of English self-test