Sony CHC-CL3 - Manual (Page 11)

CD
11
Programing CD tracks
— Program Play
You can make a program of up to 25 tracks.
1
Press FUNCTION repeatedly to switch
the function to CD.
2
Press PLAY MODE/DIRECTION
repeatedly until “PGM” appears.
3
Press CD 1 – 3 to select a CD.
To program all the tracks on a CD at once,
proceed to step 5 with “AL” displayed.
4
Turn ./> (or press . or > on
the remote) until the desired track
number appears.
Playing time of the selected track
Selected CD and track number
5
Press ENTER/YES on the remote.
The track is programed.
“STEP” appears, followed by the number of
the track in the programed sequence. The
number of the last programed track appears,
followed by the total playing time of the
program.
Total playing time
Last programed track number
6
To program additional tracks, repeat
steps 3 to 5.
7
Press CD NX (or N on the remote).
To Do this
Press PLAY MODE/
DIRECTION repeatedly until
“PGM” and “SHUFFLE”
disappear.
Check the
program Press CHECK on the remote
repeatedly in stop mode. After
the last track, “Check End”
appears.
Clear a track
from the end Press CLEAR on the remote in
stop mode.
Clear a
specific track Press CHECK on the remote
repeatedly in stop mode until the
number of the track to be erased
lights up, then press CLEAR.
Add a track to
the program in
stop mode Perform steps 3 to 5.
Tips
• The program you made remains after Program Play
finishes. To play the same program again, press CD
NX.
• “- -.- -” appears when the total CD program time
exceeds 100 minutes, or when you select a CD track
whose number is 21 or over.
Cancel
Program Play