Sony CHC-CL3 - Manual (Page 20)

20
Adjusting the sound
Enjoying the powerful sound
— GROOVE
You can listen to music with more powerful
sound.
Press GROOVE.
“GROOVE” appears in the display and the
volume switches to power mode (DBFB is also
turned on).
Press again to cancel GROOVE.
DBFB is also canceled.
Tip
GROOVE is factory set to on.
Reinforcing the bass sound
— DBFB
You can listen to music with stronger bass
tones.
Press DBFB * .
“DBFB” appears in the display and the bass is
reinforced.
Press again to cancel DBFB.
* DBFB: Dynamic Bass Feedback
Tip
DBFB is factory set to on.
Selecting the surround effect
Press SURROUND on the remote.
“SURROUND” appears in the display.
Press again to cancel SURROUND.
Timer recording radio programs
(continued)
6
Insert a recordable tape.
Recording starts from the top side. Insert a
tape with the side you want to record on
facing up.
7
Press ?/1 to turn off the system.
To Do this
Check the setting Press CLOCK/TIMER
SELECT on the remote and
turn ./> (or press
. or > on the remote)
to select “REC SELECT?”,
then press ENTER/YES on
the remote.
Change the setting Start over from step 1.
Cancel the timer Press CLOCK/TIMER
SELECT on the remote and
turn ./> (or press
. or > on the remote)
to select “TIMER OFF”, then
press ENTER/YES on the
remote.
Notes
• Do not operate the system from the time the system
turns on until the recording starts (about 30 seconds
before the preset time).
• If the system is on about 30 seconds before the
preset time, the timer-recording will not be
activated.
• The volume is reduced to minimum during
recording.
Sound Adjustment