Sony PDW-F30 - Manual (Page 20)

20
Names and Functions of Parts
Ch
apt
er 1 Ov
e
rv
ie
w
STANDBY button: Press this button to put the unit into
standby-off mode (the STOP button lights, and the
STANDBY indicator off). Press it again to return to
the original state (the STOP button lights, and the
STANDBY indicator lights).
This unit has a function that can put it into standby-off
mode automatically after a certain length of time passes in
disc stop mode. For details, see the explanation of STILL
TIMER in the setup menu (page 85).
e TS REC (transport stream record) button
Press this button together with the PLAY button to start
recording. Recording starts on the unrecorded part of the
disc.
Press the STOP button to stop recording. A clip is created
from the recorded section.
This button is enabled when you record TS input signals
(when the PDBK-102 MPEG-TS Input/Output Board is
installed) or the signals of the internal signal generator.
Rear Panel
1 Analog video signal output section
a COMPOSITE OUT connectors (phono jack, BNC
type)
These output composite video signals.
When CHAR SEL on the HOME page of the function
menu is set to “ON” (see page 78), information such as
timecode, menu settings, and error messages is
superimposed on the output signals.
b MONITOR connector (D-sub 15-pin)
This outputs HD analog video signals. The output signals
can be switched with INTERFACE SELECT >D-SUB
OUTPUT in the setup menu (see page 87).
2 Analog audio signal output section
Note
- AC IN
POWER
COMPOSITE OUT AUDIO MONITOR
AUDIO OUTPUT
1/3 2/4
R L
RS232C REMOTE(9P)
S400
MONITOR
4 External device connection
section
2 Analog audio signal
output section
3 Power supply
section
1 Analog video signal
output section
COMPOSITE OUT
MONITOR
1 COMPOSITE OUT connectors
2 MONITOR
connector
AUDIO OUTPUT
1/3 2/4
AUDIO MONITOR
R L
1 AUDIO OUTPUT 1/3 and 2/4
connectors
2 AUDIO MONITOR
connectors