Sennheiser EK 2000 IEM - Manual (Page 14)

13
Using the diversity receiver
Using the diversity receiver
To establish a transmission link, proceed as follows:
1. Switch the diversity receiver on (see next section).
2. Switch a transmitter on (see the instruction manual of the trans-
mitter).
The transmission link is established and the receiver’s RF level display
“
RF ” ቢ reacts.
If you cannot establish a transmission link between transmitter and
receiver, read the chapter “Synchronizing a transmitter with the diversity
receiver” on page 28.
Switching the diversity receiver on/off and adjusting
the volume
To switch the diversity receiver on :
̈
Turn the volume control ³ clockwise until it clicks.
The red ON LED ¿ lights up. The “ Frequency/Name ” standard display
appears on the display panel.
To switch the diversity receiver off :
̈
Turn the volume control ³ counterclockwise until it clicks.
The red ON LED ¿ goes off and the diversity receiver switches off.
It is vital to observe the notes on frequency selection on page 28.
¿
ᕡ