Sennheiser EK 2000 IEM - Manual (Page 29)

28
Synchronizing a transmitter with the diversity receiver
Synchronizing a transmitter with the
diversity receiver
Setting the transmitters to intermodulation-free
channels (
Easy Setup Sync )
Upon delivery, the SR 2000 IEM or SR 2050 IEM transmitter and the diver-
sity receiver are synchronized with each other. If, however, you cannot
establish a transmission link between transmitter and diversity receiver,
you first have to use the diversity receiver to determine intermodulation-
free channels and then transfer these channels to the transmitters.
In doing so, no transmission links are established.
̈
On all transmitters, call up the “ Easy Setup ” menu item.
“ Easy Setup Sync ” appears on the display panels of the transmitters.
The RF signals of the transmitters are deactivated. The transmitters
await the transfer of a channel and a frequency bank via their infra-red
interfaces.
̈
With a diversity receiver, perform a frequency preset scan to scan the
frequency banks for unused channels (“
Scan New List ”, see page 21).
̈
Select a frequency bank with a sufficient number of unused channels
and a channel on this receiver (“
Current List ”, see page 21).
When synchronizing the SR 2000 IEM or SR 2050 IEM transmitter
with a diversity receiver, please observe the following:
̈
Only use a transmitter and a diversity receiver from the same
frequency range (see the type plates on the transmitter and
the diversity receiver).
̈
Make sure that the desired frequencies are listed in the
enclosed frequency information sheet.
You can also contact your Sennheiser partner who will be
pleased to calculate intermodulation-free frequencies for you.
̈
Make sure that the desired frequencies are approved and
legal in your country and, if necessary, apply for an operating
license.