SpectraLink h340 - Manual (Page 18)

SpectraLink Corporation Configuration and Administration—NetLink e340/h340/i640 Wireless Telephone
with SIP
PN: 72-1089-02-D.doc Page 18
Admin Menu Items 2 nd Level 3 rd Level 4 th Level 5 th Level
5 mW
Diagnostics Run Site Survey
Diagnostics Mode Diagnostics On
*Diagnostics Off
Syslog Mode *Disabled
Errors
Events
Full
Restore Defaults
* default setting
†50 mW and 30 mW only appear if Regulatory Domain is set to None or 01.
Phone Config
License Option
License Option lets you select the VoIP protocol that your site is licensed to
download and run. The SIP protocol used for the NetLink e340/h340/i640 Wireless
Telephones requires license option selection 11 . Any other protocol will cause the
handset to malfunction.
SIP Registration
Individual handsets may be configured to correspond with the SIP configuration
information in the TFTP server. The handset is then automatically identified at
startup. If username and password information is not configured in the Admin
menu, then this information will be requested at startup
In either case, the username and password must agree with a corresponding
configuration file. See Section 6.1 SIP TFTP Server Configuration Files.
Reg 1 and Login allows you to specify a username and password for automatically
acquiring SIP configuration information. If no username is specified, the SIP handset
will request username and password at startup and any additional registrations
specified here are ignored.
The username should correspond to the primary (line 1) dial number assigned to the
user. The username and password should also correspond to the authentication
credentials as created by your system administrator for your primary line registration.
Usernames or passwords can be erased by selecting the item, then pressing Bksp
softkey and then Save softkey.
Reg 2 , Reg 3 , and Reg 4 allow you to specify additional authentication usernames
and passwords that may be required by your handset for any additional line
appearances (registrations) that may appear in the specific user’s configuration file.
This information will be ignored if a Reg 1 and Login username is not provided.
OAI On/Off
SpectraLink’s Open Application Interface (OAI) enables third-party computer
applications to display alphanumeric messages on the handset display and take input
from the handset keypad. Refer to the OAI Specification (Version 2.0)
documentation for information about administering the OAI Gateway and the
services it can provide.
If you have an OAI Gateway installed in your system, OAI may be optionally
enabled in each handset. You may select whether the handset should attempt to