SpectraLink h340 - Manual (Page 56)

SpectraLink Corporation Configuration and Administration—NetLink e340/h340/i640 Wireless Telephone
with SIP
PN: 72-1089-02-D.doc Page 56
Message Description Action
Erasing Memory Handset has determined that a download
should occur and is erasing the current
software from memory.
None. When the progress bar fills the
display line the erase operation is
complete.
Do not turn the handset off during this
operation.
Files Too Big Handset software download files are
incorrect or corrupted.
Download new software from the
SpectraLink website per Software
Maintenance .
Flash Config Error Handset internal configuration is corrupt. Perform "Restore Defaults" operation via
administrator menus (or re-program with
Configuration Cradle).
Initializing … The handset is performing power-on
initialization.
None. This is informational only.
Internal Err. # # The handset has detected a fault from which
it cannot recover.
Record the error code so it can be
reported.
Turn the handset off then on again.
If error persists, try registering a different
handset to this telephone port.
If error still persists, contact SpectraLink
Technical Support and report the error.
Multiple GW Res More than one NetLink SVP Server has
responded.
Caused by two or more handsets sharing
the same IP address. Assign unique IP
addresses to each handset.
Multiple SVP Reg
yyy.yyy.yyy.yyy
y…y = SVP IP address
Handset received responses from multiple
SVP Servers; displays IP address of one
responding SVP Server.
This can happen if the handset has been
reconfigured to use a different SVP server
and then powered up before the previous
server has had time to determine that the
handset is no longer connected to it. The
problem should go away after about 30
seconds.
Must Upgrade SW! Handset software is incompatible with
hardware.
Download new software from the
SpectraLink website per Software
Maintenance .
Net Busy
xxxxxxxxxxxx
x…x = AP MAC address.
Handset cannot obtain sufficient bandwidth
to support a call; displays MAC of failing AP.
Try the call again later.
No DHCP Server Handset is unable to contact the DHCP
server.
Check that DNCP is operational and
connected to WLAN or use Static IP
configuration in the handset.
No ESSID Attempted to run Site Survey application
without an ESSID set.
Let handset come completely up.
Statically configure an ESSID in the Admin
menu.
No Func Code Handset software download files are
incorrect or corrupted.
Reconfigure the handset to gain access to
the WLAN and download new code.
No Host IP The handset is configured for “static IP” (as
opposed to “use DHCP”) and no valid host IP
address (the handset’s IP address) has been
entered.
Enter a valid IP address in the
configuration settings or change to “use
DHCP.”