SpectraLink h340 - Manual (Page 22)

SpectraLink Corporation Configuration and Administration—NetLink e340/h340/i640 Wireless Telephone
with SIP
PN: 72-1089-02-D.doc Page 22
SpectraLink and Cisco Systems have cooperated to implement the Fast Secure
Roaming mechanism. FSR is designed to minimize call interruptions for NetLink
Wireless Telephone users as they roam throughout a facility. Existing Aironet 350,
1100, and 1200 APs may require a firmware upgrade to support FSR. Cisco FSR
requires advanced configuration of the Cisco APs in your site. See your Cisco
representative for detailed documentation on configuring the APs and other required
security services on the wired network. To configure Cisco FSR on a handset, you
must enter a Radius Server username and password into each handset.
Username Enter a username that matches an entry on the Radius server.
Usernames are alphanumeric strings, and can be entered using the alphanumeric
string entry technique.
Password Enter the password that corresponds to this Username.
WPA-PSK The security features of WPA (Wi-Fi Protected Access) using PSK (pre-
shared key) are available and may be used if supported by the APs in the facility.
Select either Passphrase and enter a passphrase between eight and 63 characters in
length or Direct Entry and enter the 256-bit key code.
WPA2-PSK The security features of WPA2 (Wi-Fi Protected Access) using PSK are
available and may be used if supported by the APs in the facility. Select either
Passphrase and enter a passphrase between eight and 63 characters in length or
Direct Entry and enter the 256-bit key code.
 Consult the Configuration Note for the APs installed in your facility for
information on which of the WPA versions are recommended by SpectraLink
engineering. Configure the recommended version on the AP and select the
corresponding option on the Admin menu.
Regulatory Domain
The Regulatory Domain will default to None on the handset display. FCC
requirements dictate that the menu for changing the domain be available by
password, which in this case is the LINE key. To change the domain, press LINE and
then enter the digits that represent the site’s domain. Note that both digits must be
entered.
01 North America
02 Europe (except Spain and France); Japan (channels 1-13)
04 Spain
05 France
 As of this writing, Spain and France are adopting the general European
regulatory rules. Check with your wireless LAN administrator or supplier
regarding which domain to enter in these countries.
Transmit Power
Available Transmit Power is regulated by domain. The Regulatory Domain setting
above affects the options available for this setting. The default setting is Maximum
which in North America is 100 mW. The Maximum in other domains is 30 mW.
Transmit Power may be set to a lower number if necessary by selecting one of the