SpectraLink h340 - Manual (Page 23)

SpectraLink Corporation Configuration and Administration—NetLink e340/h340/i640 Wireless Telephone
with SIP
PN: 72-1089-02-D.doc Page 23
other levels. If changed from the default, ensure the Transmit Power setting is the
same on all handsets and all APs.
 Power is limited to 30mW in regulatory domains other than North America.
Diagnostics
Run Site Survey
The Site Survey mode is activated by selecting this option. The site survey starts
running immediately upon selecting this option. See the Diagnostic Tools section for
more information about site survey.
Diagnostics Mode
See the Diagnostic Tools section for a detailed explanation of the Diagnostics Mode
options.
Syslog Mode
See the Diagnostic Tools section for a detailed explanation of the Syslog Mode
options.
Restore Defaults
The Restore Defaults option will set all user and administrative parameters except
License Option to their factory defaults.
3.2 User-defined Preferences
The following user-defined preferences are also covered in the NetLink
e340/h340/i640 Wireless Telephone User Guide. The system administrator can refer
to this list for more information about customizing handset settings.
To configure the following options, the handset must acquire the system (no error
message may display) and be at the extension display. This is the standby mode.
While in the standby mode, press and hold FCN briefly to open the user options
menu. Use the following keys to display and select options:
Up/Down buttons: Display previous/next menu item.
Select button: Selects the menu item or option.
OK softkey: Selects the menu item or option.
Save softkey: Saves the entry.
Bksp softkey: Backspaces to allow editing of entry.
Cncl softkey: Cancels edit and return to previous menu level.
Up softkey: Returns to previous menu level.
Exit softkey: Exits the menu (at the top level).
End Call key: Exits to standby state (from any level).