Symbol Technologies MC50 - Manual (Page 66)

MC50 Integrator Guide 3-12
Battery Charging
To charge the mobile computer’s battery through the CAM, attach the CAM to the mobile computer, then connect the power supply
to the CAM. The mobile computer begins charging.
Figure 3-11. CAM Power Connection
The mobile computer’s charge LED shows the status of the battery charging in the mobile computer. See Table 1-2 on page 1-7 for
charging status indications. The standard battery fully charges in approximately 2.5 hours and the extended capacity battery fully
charges in approximately five hours.
USB Connection
The CAM can connect to and communicate with a USB device, such as a host computer, through its data port. Refer to the MC50
Integrator Guide for the host computer communication setup procedure.
To connect the CAM to a USB device, connect one end of the data cable to the data port on the CAM and the other end to the USB
port on the device.
Into Cigarette Lighter
Into Cigarette Lighter AC Power Supply