SMSC EZ Card 10 - Manual (Page 12)

The procedure for installing the EZ Card 10 PCI models appears
below. Although instructions for installing the software drivers
are not included here, some related information is provided.
1. Power off your PC and remove its cover.
Please refer to your computer's Installation Manual for
instructions on how to remove the cover.
2. Select an available expansion slot and plug in the card.
The card provides a 32-bit bus interface. It plugs into any
available PCI expansion bus slot. Remove the protector
bracket from the slot you selected. Insert the card into the
slot. Carefully press on the card until all the edge connec-
tors are firmly in place inside the slot. Screw the card's steel
bracket into the PC to secure the connection. Replace the
PC cover.
3. Connect your card to the network.
Select a cable type for your application and attach the card
to the network using the appropriate connector:
• RJ-45 for twisted-pair cable
• BNC for thin coax cable
• AUI for thick coax cable
C
HAPTER
2
I
NSTALLING THE
C
ARD
2-1
EZ Card PCI 3/31/98 4:18 PM Page 2-1