SMSC EZ Card 10 - Manual (Page 13)

4. Power on the PC.
Hardware installation has been completed. Switch on power
to the PC.
Note: Your network should be configured automatically by
the PCI computer’s BIOS Setup Program. However,
some manual configuration may be required in older
PCI machines. Refer to “Configuring the Card in
Older PCI Computers” in Appendix C for related
information.
5. Run the Diagnostic program to check the card's hard-
ware installation.
For related topics, see “Running the Setup Program” in
Appendix C.
Caution! Be sure to run this program before installing the
appropriate driver. Otherwise, your PC will hang.
6. Install the driver.
The driver diskette contains all the driver programs supported
by these cards. Refer to the RELEASE.TXT file in the root
directory for a listing of these programs. The drivers for
different network operating systems are contained in sepa-
rate subdirectories. Refer to the Readme text file in each
subdirectory for instructions on driver installation.
I NSTALLING THE C ARD
2-2
EZ Card PCI 3/31/98 4:18 PM Page 2-2