Standard Horizon CPV550 - Manual (Page 118)

Page 118 CPV550
20.1 UNIT NAME
This selection allows you to provide the name to the radio and optional RAM+ or VH-310
Handset when connected.
1. Select the chart page and press the [MENU] key two times. Move the ShuttlePoint knob
to highlight RADIO SETUP and press the [ENT] key or move the ShuttlePoint knob to
the right.
2. Move the ShuttlePoint knob to highlight VHF SETTING and press the [ENT] key or move
the ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight UNIT NAME and press the [ENT] key or move
the ShuttlePoint knob to the right.
4. Move the ShuttlePoint knob to select the Unit (CP, RAM1, or RAM2) to be named and
press the [ENT] key or move the ShuttlePoint knob to the right.
5. Move the ShuttlePoint knob to up or down to scroll through the first letter of the unit
name. You may enter the name from the keypad. For example: press the [1] key
repeatedly to toggle among the four available characters associated with that key:
AÆBÆCÆ1.
6. Move the ShuttlePoint knob to the right to enter the first character and step to the next
letter to the right.
7. Repeat step 5 and 6 until the name is complete. The name can consist of up to twelve
characters.
8. Press the [CLR] key until the menu disappears or an easier method is to move the
ShuttlePoint knob to the left a few times.
Figure 20.1 - UNIT NAME menu