Standard Horizon CPV550 - Manual (Page 99)

Page 99 CPV550
19.1.1 Programming the MMSI
WARNING
User MMSI can be input only twice. If the user tries to input an MMSI more than twice,
the radio will show the display on the right. If the user needs to change the MMSI
more than twice, the transceiver will have to be sent to Factory Service. Refer to the
section “23.1 FACTORY SERVICE.”
1. Select the chart page and press the [MENU] key two times. Move the ShuttlePoint knob
to highlight RADIO SETUP and press [ENT] or move the ShuttlePoint knob to the right.
2. Move the ShuttlePoint knob to highlight DSC SETTINGS and press [ENT] or move the
ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight USER MMSI and press [ENT] or move the
ShuttlePoint knob to the right.
4. Enter your MMSI (up to nine digits) from the keypad.
5. Press the [ENT] to store the number in memory.
6. Press [CLR] until the menu disappears or an easier method is to move the ShuttlePoint
knob to the left a few times.
Figure 19.1 - DSC SETTINGS menu
19.2 DSC DISTRESS CALL
The CPV550 is capable of transmitting and receiving DSC Distress messages from all DSC
radios. The CPV550 will transmit the Latitude, Longitude of the vessel if the GPS has a fix.
19.2.0 Transmitting a DSC Distress Call
NOTE
To be able to transmit a DSC distress call an MMSI number must be programmed, refer to section
“19.1.1 Programming the MMSI.” In order for your ships location to be transmitted a GPS antenna
must be connected to the CPV550, refer to section “2.3 MOUNTING THE GPS WASS SMART
ANTENNA.”
1. Lift the red spring loaded DISTRESS cover and press [DISTRESS]. “DISTRESS
ALERT” popup window will appear on the display.
2. Press and hold the [DISTRESS] key. The radios display will count down (3-2-1) and
then transmit the Distress call.