Standard Horizon CP180 - Manual (Page 20)

Page 22 CP180 / CP180i
The MARK key
Places a Mark under the ships position when in Home Mode (in Cursor Mode under the
cursor).
The ROUTE key
When pressed places a Waypoint. Succeeding presses place more Waypoints to form a Route.
The PWR key and Lamp/Contrast
Press and hold [PWR] to turn the GPS chart plotter on or off. Once on, press [PWR] to show
the Contrast and Lamp popup window.
The MOB key
When pressed the GPS chart plotter automatically places a Mark on the Chart page and all
navigation is towards the position of the MOB Mark.
The INFO key
When pressed searches and shows information on the selected point.
3.1 GETTING STARTED
The Getting Started section will take you through the frequently used operations and assist
you to customize the look of the GPS chart plotter.
Legend:
[MENU] If you see brackets around a bold and capital letter word this refers to a key press.
GENERAL SETUP When a word(s) is bold capital letters and underlined, this refers to a menu selection item.
3.1.0 Power On, Off and ShuttlePoint knob operation
1. Press and hold [PWR] until the display shows the start-up page. To turn off, press and
hold [PWR] until the display turns off.
2. When the power is first turned on two pages the start-up page (see the following picture)
and the Caution page are briefly shown before the GPS Status page.
Figure 3.1.0 - Example of Start-Up page on CP 180
3. When the GPS chart plotter is first turned on it will take some time for the GPS to acquire
a fix of your position. Look closely at the GPS Status page and you will see satellites and
relative signal strengths.
After a fix is received the GPS chart plotter will automatically
switch to the Chart page with the ships icon centered on the screen.