0 saving and starting a new track, 1 other settings in track menu, 1 using the trip log – Standard Horizon CP180 User Manual
Page 54
Page 56
CP180 / CP180i
Figure 10.0 - Tracking
10.0.0 Saving and starting a new Track
A Track is automatically saved to memory. To start a new Track:
1. Press [MENU]. Move the ShuttlePoint knob to highlight USER POINTS and press
[ENT].
2. Move the ShuttlePoint knob to highlight TRACK and press [ENT].
3. Move the ShuttlePoint knob to highlight ACTIVE TRACK and press [ENT] or move the
ShuttlePoint knob to the right.
4. Move the ShuttlePoint knob up/down to select the next available open Track and press
[ENT] or move the ShuttlePoint knob to the right.
5. Move the ShuttlePoint knob to highlight TRACKING and press [ENT] or move the
ShuttlePoint knob to the right to set On.
6. Press [CLR] or move the ShuttlePoint knob to the left until the Chart page is shown.
7. A new Track now will be laid down.
10.0.1 Other Settings in Track Menu
You will notice the Track menu has other selections:
TRACKING
Allows turning on or off the tracking function
ACTIVE TRACK
This selection allows you to save a Track to one of the 5 Tracks available
VISIBLE
Shows or hides a Track shown in ACTIVE TRACK menu
LINE COLOR
Selects the color of the Track line
DELETE
Deletes a Track selected in the ACTIVE TRACK menu
STEP UNIT
Allowable selection are Distance or Time
DISTANCE
Setup the Distance interval the Track point is placed on the Chart page
TIME
Setup the TIME interval the Track point is placed on the Chart page
10.1 USING THE TRIP LOG
On the Chart, Navigation, Highway and NMEA Data pages the windows may be customized
to show TRIP LOG information.
1. Select one of the pages listed above, press and hold [MENU]. You will notice one of the
data boxes will be highlighted.
2. Press [ENT] and move the ShuttlePoint knob to highlight TRIP LOG, press [ENT] or
move the ShuttlePoint knob to the right.
3. A popup window will be shown with Nm (Nautical Mile), Sm (Statute Mile), Km
(Kilometer) and RESET. Move the ShuttlePoint knob to select the desired units of
measure and press [ENT] or move the ShuttlePoint knob to the right.