Standard Horizon CP180 - Manual (Page 35)

CP180 / CP180i Page 37
6. MAP FUNCTIONS
6.0 MAX FUNCTIONS MENU
1. Press [MENU]. Move the ShuttlePoint knob to highlight SETUP MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight MAX FUNCTIONS and press [ENT] or move
the ShuttlePoint knob to the right. The new MAX Functions menu appears on the screen:
Figure 6.0 - Map Functions Menu
The available Functions are described in the following.
6.0.0 Zoom Type
Allows more expansions or compression of the chart scale while zooming in or out. Zoom
Mode has two options; STANDARD (default) or FLEXI-ZOOM. When in FLEXI-ZOOM
mode, a short [ZOOM...] push causes a change of chart, while a long [ZOOM...] push (press
and hold) causes a pop-up window to be displayed on a corner of the screen. The window
shows the current Zoom Factor. By pressing [ZOOM IN]/[ZOOM OUT] the map is expanded
or compressed according to the zoom factor selected. The window is automatically closed
if [ZOOM...] is not pressed for 2 seconds and the selected zoom factor will be used at the
next zoom in/out.
To activate this function follow the procedure:
1. Press [MENU]. Move the ShuttlePoint knob to highlight SETUP MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight MAX FUNCTIONS and press [ENT] or move
the ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight ZOOM TYPE and press [ENT] or move the
ShuttlePoint knob to the right.
4. The menu now shows two selections, STANDARD or FLEXI-ZOOM.
5. Move the ShuttlePoint knob to select the selection and press [ENT].
6. Press [CLR] until the menu disappears or an easier method is to move the ShuttlePoint
knob to the left a few times.
6.0.1 Perspective View
Chart data may be projected in perspective mode during navigation. This function allows
setting the panoramic View of the chart. As the upper side of the map is more compressed
than the lower side, a wider map area is visible. The perspective view allows showing more
chart information immediately ahead and around the cursor.