Sharp MD-C2H - Manual (Page 10)

<P=004>
SETTING THE CLOCK
1
Press the ON/STAND-BY button to turn the power on.
2
Press the CLOCK button.
3
Within 5 seconds, press the ENTER button.
4
Turn the jog dial to select the time display mode.
"0:00" → The 24-hour display will appear.
(0:00 - 23:59)
"12:00 AM"
→ The 12-hour display will appear.
(AM or PM 12:00 - 11:59)
"0:00 AM"
→
The 12-hour display will appear.
(AM or PM 0:00 - 11:59)
● Note that this can only be set when the unit is first installed
or it has been reset (see page 53).
5
Press the ENTER button.
6
Adjust the hour by turning the jog dial.
● When the jog dial is turned one click clockwise, the time will
increase by 1 hour. When it is turned one click anti-clockwise,
the time will decrease by 1 hour.
Keep turning the jog dial to change the time continuously.
● When the 12-hour display is selected, "AM" will change auto-
matically to "PM".
7
Press the ENTER button.
8
Adjust the minutes by turning the jog dial.
● When the jog dial is turned one click clockwise, the time will
increase by 1 minute. When it is turned one click anti-clockwise,
the time will decrease by 1 minute.
Keep turning the jog dial to change the time continuously.
● The hour setting will not advance even if minutes advance from
"59" to "00".
9
Press the ENTER button.
● The clock starts operating from "0" seconds.
(Seconds are not displayed.)
Note:
● In the event of a power failure or when the AC power lead is
disconnected, the clock setting will be lost. Reset the time.
12:00 AM 0:00 AM 0:00
2
3
4
7
6
5
8
9
To change the clock time:
①
Press the CLOCK button.
②
Within 5 seconds, press the ENTER button.
③
Perform steps 6 - 9 above.
To see the time display:
Press the CLOCK button.
● The time display will appear for about 5 seconds.
To change the time display mode:
①
Perform steps 1 - 2 in the section "If a problem occurs", on
page 53.
②
Perform steps 1 - 9 above.
In this example, the clock is set for the
24-hour (0:00) system.
Jog dial
CLOCK
ON/
STAND-BY
ENTER
MD-C2H(SUK) TINSE0238AWZZ
9