Sharp MD-C2H - Manual (Page 53)

2
HK <P=001>
(Continued)
When an error message is displayed, proceed as follows:
Error messages Meaning Remedy
BLANK MD ● Nothing is recorded. ● Replace it with another disc.
Can’t EDIT ● A track cannot be edited. ● Change the stop position of the track and then
try editing it.
Can’t REC ● Recording cannot be performed correctly due
to vibration or shock in the unit.
● The tape is protected against accidental
erasure.
● Re-record or replace the MiniDisc.
● Cover the accidental erase prevention hole.
CD NO DISC ● A CD has not been loaded.
● The disc data cannot be read.
● Load a CD.
● Reload the CD.
DEFECT ● Since this disc has scratches on it, the recor-
ding operation was skipped. ● Replace it with another recordable disc.
DISC FULL ● The MiniDisc is out of recording space. ● Replace it with another recordable disc.
EDIT OVER ● There is no space to make CD editing on the
disc. ● Replace it with a disc that has enough time
to record.
FOCUS ERR ● A disc has not been loaded.
● The disc data cannot be read.
● Reload the MiniDisc.
MD
∗∗
ERR
( ∗ :Number or
symbol)
● The disc is damaged.
● A TOC is not written on the MD or there is
something wrong with data.
● Reload the disc or replace it.
MD ERR ● Trouble is found. ● Contact the shop where you purchased the
unit.
MD NO DISC ● A MiniDisc has not been loaded.
● The disc data cannot be read.
● Load a MiniDisc.
● Reload the MiniDisc.
MECH
∗
ERR
(
∗
:Number or
symbol)
● There is a mechanical problem and the disc
is not working properly. ● Set this unit to the stand-by mode and press
the MD EJECT button.
NAME FULL ● The number of characters for the disc name
or track name exceeds 40. ● Shorten the disc or track name.
NOT AUDIO ● The data recorded on this disc is not audio
data. ● Select another track.
● Replace the disc.
PLAY MD ● You tried to record on a playback-only. ● Replace it with another recordable disc.
PROTECTED ● The disc is write protected. ● Move the write protection tab back to its orig-
inal position.
TEMP OVER ● The temperature is too high. ● Set this unit to the stand-by mode and wait
for a while.
TOC
∗∗
ERR
( ∗ :Number or
symbol)
● The disc is damaged.
● TOC information cannot be read.
● MD not specified.
● Replace it with another disc.
TOC FULL
∗
(
∗
:Number or
symbol)
● There is no space left for recording character
information (track names, disc names, etc.). ● Replace it with another recordable disc.
TOC W ERROR ● Recording is impossible. ● Contact the shop where you purchased the
unit.
TRAY ERROR ● The CD tray operates incorrectly. ● Unplug the AC power lead, plug it back, and
then turn the power on.
MD-C2H(SUK) TINSE0238AWZZ
52