Sharp AR-164 - Manual (Page 18)

16
MAKING COPIES
1 Turn the power switch on.
● It will take about 35 seconds for the copier to warm up. However, you
can make desired settings and press the START key during warm-up.
Copying will start after warm-up.
● If the copier has been programmed in the auditing mode, the START
key indicator will not light up and “– – – ” will appear in the copy
quantity display. Enter an assigned 3-digit account number. See page
13.
● If the power is already on and all indicators except the POWER SAVE
indicator are off, the copier is in the auto power shut-off mode. Press
the START key in this case. See page 53, POWER SAVE MODES.
2 Place the original face down on the original table. Align
it with the original size scale.
● Image loss (max. 5/32" (4 mm)) can occur at the leading and trailing
edges of the copies. Also image loss (max. 5/32" (4 mm) in total) can
occur along the other edges of the copies.
3 Close the platen cover.
4 Ensure that the copy paper size in the paper tray is the
same size as the original.
● If a tray of the required size is not installed, use the bypass tray and
press the TRAY SELECT key to select the bypass tray.
● If an optional paper feed unit is installed:
Use the ORIGINAL SIZE ENTER key to select the original size. Copy
paper of the same size as the original will be automatically selected.
If desired, another paper tray can be selected by pressing the TRAY
SELECT key.
5 Adjust the copy density.
● This copier has three exposure modes to choose from — AUTOMATIC,
MANUAL, and PHOTO.
● Automatic exposure is the standard initial setting for this copier. In this
mode, the characteristics of the original are “read” by the exposure
system and adjustments are automatically made. This optimizes the
contrast of the copied images by reducing the effect of colored or
shaded background areas. See page 26 to adjust the automatic exposure
level.
Normal copying
NORMAL COPYING
Using the original table
Power on