Sharp AR-164 - Manual (Page 48)

46
GENERAL INFORMA
TION
User programs
USER PROGRAMS
The user programs allow the parameters of certain functions to be set,
changed, or canceled as desired.
List of user programs
This copier has the following user programs.
Program No. Program name Description
1 Auto clear time Sets the auto clear time. The copier returns to the initial settings when
the auto clear time elapses after the last copy is made.
2 Preheat mode Sets the time that elapses before the copier enters the preheat mode after
any operation is made. See page 53.
3 Auto power shut-off Sets the time that elapses before the copier enters the auto power
timer shut-off mode after any operation is made. See page 53.
4 Stream feeding Enables or disables the stream feeding mode. See page 14.
mode
5 Auto power shut-off Enables or disables the auto power shut-off mode. See page 53.
setting
6 Border line for 2 in 1 or Enables or disables the border line which is printed in 2 in 1 or 4 in 1
4 in 1 copying. See page 33.
7 Rotation copy Enables or disables rotation of original images. See page 32.
8 Auto paper select mode Enables or disables the auto paper selection. See page 14.
9 Auto tray switching* Enables or disables the automatic tray switching which occurs when paper
in a tray runs out. (This switching cannot switch to the bypass tray.)
10 Auditing mode Enables or disables the auditing mode, which controls access to
copier. See page 13.
11 Account number Registers accounts for auditing mode.
entry
12 Account number Changes account numbers for auditing mode.
change
13 Account number Deletes accounts for auditing mode.
deletion
14 Number of copies Displays the total number of copies made against account numbers.
per account
15 Resetting account Resets all audit accounts or resets any desired individual account.
16 Erase width adjustment Sets the amount of the edge erase and center erase areas. See page 35.
17 Layout in 2 in 1 copy Selects a pattern for 2 in 1 copying. See page 33.
18 Layout in 4 in 1 copy Selects a pattern for 4 in 1 copying. See page 33.
19 Offset of paper output Enables or disables the offset function of the paper output tray. The offset
tray function can be specified respectively for the upper and lower areas
separated by an optional job separator tray. See page 23.
* This program does not affect the copier functions unless certain optional equipment is installed.