Simrad AP25 - Manual (Page 133)

Configuration and setup
20221495F
131
Under Service in the Installation
Menu, select NMEA port test by
pressing the STBD button and
confirm this by rotating the course
knob clockwise.
Verify that the hardware is OK. If
not, replace the corresponding
PCB(‘s).
Proceed to the Simnet Setup menu by pressing the STBD button,
or press STBY to return to normal AP25 operation.
Simnet setup
Group selection
SIMRAD: Autopilot is part of the
Simrad Group. Source selection will
be common for the products in the
group (synchronized).
STAND ALONE: Source selection
for the autopilot will not be
transferred to other products in the
Simrad Group (no synchronization).
Backlight Illumination
Set backlight to synchronize with
one of the illumination banks (1-3)
available on the SimNet, or to
STAND ALONE for individual
control of the autopilot illumination.
Instance number
An item to identify units by a
number when the autopilot is
connected to a NMEA2000
Network. On SimNet units the
Instance number is added to the
product name e.g. AP25-1, AP25-2
for easy identification on various
display screens.