Sharp UX-A1000 - Manual (Page 36)

Operating the Answering System
34
To listen to the outgoing message
To listen to the outgoing message, follow Steps 1 and 2 of the above
procedure and then press . Note that the general outgoing message
cannot be erased. If you need to change it, simply repeat the recording
procedure.
Operating the Answering System
Activating the answering system
To turn on the answering system so that callers can leave messages, press
until the arrow in the display points to TAD. (TAD stands for
“Telephone Answering Device”.)
PLAY
RESOLUTION/
RECEPTION MODE
4
Press and speak into the handset to record a message.
•
The outgoing message can be up to 60 seconds long. While recording, the
display will show the time left to record.
5
When finished, replace the handset or press .
START/
MEMORY
STOP
RESOLUTION/
RECEPTION MODE
♦
It will not be possible to set the reception mode to TAD if an outgoing
message has not been recorded.
Note: In TAD mode, the machine will automatically switch to fax reception if it
detects six seconds of silence after answering a call. For this reason, if a
caller pauses for this length of time while leaving a message, they will be cut
off.
TAD
FAX TEL
all.book Page 34 Wednesday, November 12, 2003 9:50 AM