Sharp UX-A1000 - Manual (Page 52)

Remote Operations
50
•
Erase a message: To erase the message you are currently listening to,
press and before it ends.
4
When you have finished listening to your messages, you can do any of
the following:
•
Erase all messages: Press , , and .
•
Repeat playback: Press and .
•
Perform other operations: You can enter any of the commands described
in the following section,
Other remote operations.
•
Hang up: If you do not erase your messages first, they will be saved and
any new messages will be recorded after them. If you want the machine to
resume normal operation immediately, press twice before hanging up
(in some cases, particularly when the Transfer function is used, the
machine may not accept new calls for one or two minutes after you hang up
unless you press twice).
3
3 3
7
Note: You can also call the machine and perform remote operations when the
reception mode is set to FAX. In this case, when you call the machine, press
immediately after it answers (before you hear the fax tone), and then
continue from Step 2 above.
all.book Page 50 Wednesday, November 12, 2003 9:50 AM